Hurricane Power HP-2T power supply

Output: 0-18V Selectable voltage increments: 0.1V, 0.2V, 0.5V Operating voltage: 110V-240V, frequency: 50 / 60HZ Display: Volts, Amps, Speed, Duty, Time, Timer, Preset Status.

Absolutely digital control of all its options with precision of tenths of units. Stores presets for both line and shadow machines. By default it comes configured with one preset for line machines (on the L button) and one for shadow machines (on the S button).

In the configuration menu a second and even a third unit can be enabled on each of these buttons, thus being able to store up to six different configurations.

It offers power by continuous pressure on the pedal or by the On/Off system (pressing it once to start and pressing it a second time to stop).

It offers power by continuous pressure on the pedal or by the On/Off system (pressing it once to start and pressing it a second time to stop).

At the same time press the L and S buttons for 1.5 seconds to switch from one mode to the other. By default it is set to continuous pressure feeding mode.

Its memories are of the "non-volatile" type, so they will not be lost when the power supply is disconnected from the mains.

It is prepared for use in the "non-volatile" mode.

It can be used in the "non-volatile" mode.

Comes ready for wireless footswitch operation (wireless footswitch not yet available; under development).

It communicates both with the power supply and with the wireless footswitch (wireless footswitch not yet available; under development).

Communicates with both the tattoo machine and foot pedal via universal jack connectors. Incorporates power supply holder, with quality suction cups and high power magnets, so you can secure the power supply safely to different surfaces.